LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Yukon Denali >> Repair and Diagnosis >> External Pages >> Different car >> Section 497 (Engine Mechanical (Repair Instructions -- 1 Of 3) -- 4.8L, 5.3L & 6.0L) >> Repair Instructions (On-Vehicle & Off-Vehicle - Part 1) >> On-Vehicle Repair Instructions >> Engine Mount Bracket Replacement - Right >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 GMC Yukon XL, 2004 GMC Yukon, 2004 Chevrolet Tahoe, 2004 Chevrolet Suburban, and 2004 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the engine mount bracket.
  2. Perform the following procedure prior to installing the engine mount bracket bolts.
    • Remove all traces of the original adhesive patch.
    • Clean the threads of the bolt with denatured alcohol or equivalent and allow to dry.
    • Apply threadlocker GM P/N 12345382 ( Canadian P/N 10953489) or equivalent to the bolts.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the engine mount bracket bolts.

    Tighten:  Tighten the engine mount bracket bolts to 75 N.m (55 lb ft).

    4. Fig 1: View Of Right Engine Mount Bracket & Bolts
    GM678846Courtesy of GENERAL MOTORS CORP.
  4. Install the engine mount. Refer to Engine Mount Replacement - Right .
scientia non olet · About LEMON Manuals