LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Yukon Denali >> Repair and Diagnosis >> External Pages >> Different car >> Section 497 (Engine Mechanical (Repair Instructions -- 1 Of 3) -- 4.8L, 5.3L & 6.0L) >> Repair Instructions (On-Vehicle & Off-Vehicle - Part 1) >> On-Vehicle Repair Instructions >> Engine Flywheel Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 GMC Yukon XL, 2004 GMC Yukon, 2004 Chevrolet Tahoe, 2004 Chevrolet Suburban, and 2004 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the automatic transmission. Refer to Transmission Replacement in Automatic Transmission - 4L60-E or Transmission Replacement in Automatic Transmission - 4L80-E.
    IMPORTANT: Note the position and direction of the engine flywheel before removal.
  2. Remove the flywheel bolts.
  3. Remove the flywheel.
    4. Fig 1: View Of Engine Flywheel & Bolts
    GM832979Courtesy of GENERAL MOTORS CORP.
  4. Install two M11x1.5 mm bolts (1) to the threaded holes of the spacer, if applicable.
  5. Rotate the bolts clockwise to remove the spacer.
    6. Fig 2: Installing Bolts Into Threaded Holes Of Spacer
    GM642281Courtesy of GENERAL MOTORS CORP.
  6. Remove the spacer from the rear of the crankshaft, if applicable.
    7. Fig 3: View Of Spacer & Crankshaft Rear
    GM642276Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals