LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Yukon Denali >> Repair and Diagnosis >> External Pages >> Different car >> Section 497 (Engine Mechanical (Repair Instructions -- 1 Of 3) -- 4.8L, 5.3L & 6.0L) >> Repair Instructions (On-Vehicle & Off-Vehicle - Part 1) >> On-Vehicle Repair Instructions >> Cylinder Head Replacement - Left >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 GMC Yukon XL, 2004 GMC Yukon, 2004 Chevrolet Tahoe, 2004 Chevrolet Suburban, and 2004 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the generator bracket. Refer to Generator Replacement (4.8L, 5.3L, and 6.0L Engines) in Engine Electrical.
  2. Remove the intake manifold. Refer to Intake Manifold Replacement .
  3. Remove the coolant air bleed pipe. Refer to Coolant Air Bleed Pipe Assembly Replacement (4.8L, 5.3L, and 6.0L Engines) in Engine Cooling.
  4. Remove the left exhaust manifold. Refer to Exhaust Manifold Replacement - Left (4.8L, 5.3L, and 6.0L Engines) in Engine Exhaust.
  5. Remove the pushrods. Refer to Valve Rocker Arm and Push Rod Replacement .
    IMPORTANT: The cylinder head bolts are NOT reusable.
  6. Remove the cylinder head bolts (1, 2, 3).
    7. Fig 1: Removing Left Cylinder Head Bolts
    GM832957Courtesy of GENERAL MOTORS CORP.
    NOTE: After removal, place the cylinder head on two wood blocks to prevent damage to the sealing surfaces.
  7. Remove the cylinder head.
    8. Fig 2: View Of Left Cylinder Head
    GM832958Courtesy of GENERAL MOTORS CORP.
  8. Remove and discard the cylinder head gasket.
    9. Fig 3: View Of Left Cylinder Head Gasket
    GM832962Courtesy of GENERAL MOTORS CORP.
  9. If required, clean and inspect the cylinder head. Refer to Cylinder Head Cleaning and Inspection .
scientia non olet · About LEMON Manuals