LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Yukon Denali >> Repair and Diagnosis >> External Pages >> Different car >> Section 442 (Wiring Systems (Diagnostic Information And Procedures)) >> Diagnostic Information and Procedures >> Troubleshooting with a Test Lamp

Troubleshooting with a Test Lamp

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 GMC Yukon XL, 2004 GMC Yukon, 2004 Chevrolet Tahoe, 2004 Chevrolet Suburban, and 2004 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Tools Required 

J 35616-200  12-Volt Unpowered Test Lamp

NOTE: Refer to Test Probe Notice in Cautions and Notices.

A test lamp can simply and quickly test a low impedance circuit for voltage.

The J 35616-200  is Micro-Pack compatible and comprised of a 12-volt light bulb with an attached pair of leads.

To properly operate this tool use the following procedures.

When testing for voltage:

  1. Attach 1 lead to ground.
  2. Touch the other lead to various points along the circuit where voltage should be present.
  3. When the bulb illuminates, there is voltage at the point being tested.

When testing for ground:

  1. Attach 1 lead to battery positive voltage.
  2. Touch the other lead to various points along the circuit where ground should be present.
  3. When the bulb illuminates, there is ground at the point being tested.
scientia non olet · About LEMON Manuals