LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Yukon Denali >> Repair and Diagnosis >> External Pages >> Different car >> Section 442 (Wiring Systems (Diagnostic Information And Procedures)) >> Diagnostic Information and Procedures >> Measuring Frequency

Measuring Frequency

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 GMC Yukon XL, 2004 GMC Yukon, 2004 Chevrolet Tahoe, 2004 Chevrolet Suburban, and 2004 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Refer to Test Probe Notice in Cautions and Notices.

The following procedure determines the frequency of a signal.

IMPORTANT: Connecting the DMM to the circuit before pressing the Hz button will allow the DMM to autorange to an appropriate range.
  1. Apply power to the circuit.
  2. Set the rotary dial of the DMM to the V (AC) position.
  3. Connect the positive lead of the DMM to the circuit to be tested.
  4. Connect the negative lead of the DMM to a good ground.
  5. Press the Hz button on the DMM.
  6. The DMM will display the frequency measured.
scientia non olet · About LEMON Manuals