LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Yukon Denali >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel, Gages, And Console >> Repair Instructions >> Trim Panel Replacement - Instrument Panel (I/P) Upper >> Installation Procedure

Installation Procedure

  1. Connect the electrical connector (1) to the ambient light sensor on the underside of the trim panel.
    Fig 1: Connecting Electrical Connector To Ambient Light Sensor
    G01458112Courtesy of GENERAL MOTORS CORP.
  2. Install the trim panel to the IP assembly.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the trim panel retaining screws.

    Tighten 

    Tighten the trim panel retaining screws to 2 N.m (18 lb in).

  4. Install the windshield pillar garnish moldings. Refer to GARNISH MOLDING REPLACEMENT - WINDSHIELD PILLAR in INTERIOR TRIM .
    Fig 2: Installing Trim Panel To Instrument Panel Assembly
    G01458113Courtesy of GENERAL MOTORS CORP.
  5. Align the assist handle with the holes in the IP assembly. Push the handle in order to engage the retaining tabs.
  6. Install the right side air outlets.
    Fig 3: Installing Assist Handle To IP Assembly
    G01458114Courtesy of GENERAL MOTORS CORP.
  7. Install the end panels. The left panel is shown, and the right panel is similar.
  8. Install the IP cluster trim plate bezel. Refer to BEZEL REPLACEMENT - INSTRUMENT PANEL (I/P) CLUSTER  .
  9. Tilt the steering wheel to the normal driving position.
  10. If the transmission is automatic, move the shift lever to the park position.
  11. Disengage the parking brake.
    Fig 4: Installing Instrument Panel Cluster Trim Plate Bezel
    G01458115Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals