LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Yukon Denali >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel, Gages, And Console >> Repair Instructions >> Instrument Panel (I/P) Harness Replacement >> Removal Procedure

Removal Procedure

  1. Remove the I/P carrier. Refer to INSTRUMENT PANEL (I/P) CARRIER REPLACEMENT  .
  2. Remove the driver's side hinge pillar trim panel. Refer to TRIM PANEL REPLACEMENT - HINGE PILLAR in INTERIOR TRIM .
  3. Remove the driver's side seat, if equipped with power. Refer to SEAT REPLACEMENT - FRONT BUCKET .
  4. Disconnect the electrical harness from the underhood electrical center. Refer to UNDERHOOD ELECTRICAL CENTER OR JUNCTION BLOCK REPLACEMENT .
  5. Disconnect the wire harness from the hood, if equipped with underhood camp.
  6. Remove the harness grommet from the cowl.
  7. Remove the I/P harness from the vehicle.
    Fig 1: Removing Instrument Panel Harness From Vehicle
    G01458201Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals