Trip Reset Stem

The trip reset stem on the IPC operates in the following manner with the ignition switch in the RUN position:

1. Each time the reset stem or SWC Select button is pushed the display will cycle to the next trip parameter. The trip parameters are as follows:
   • Odometer
   • Trip A odometer
   • Trip B odometer
2. Holding the reset stem for greater than 3 seconds or depressing the SWC Select button while either Trip A or Trip B odometer is displayed will reset the displayed trip odometer to 0.0 upon release of the stem. The trip odometer will remain displayed after being reset.
3. If a trip odometer parameter is being displayed, pressing the DIC Trip Information button will display the next trip odometer parameter.
4. If the next Trip Information parameter to be displayed is Timer or blank, pressing the reset stem will return the display to the Odometer.