Control Valve Body Cover Installation
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| 1 | Nylon O-Ring |
| 2 | Transmission Fluid Cooler Outlet Seal |
| 3 | A/Trans Wiring Extension Harness Assembly Procedure: Make sure you connect all four connectors on the wiring harness in the appropriate locations. Tip: The wiring harness is attached to the fluid cooler outlet pipe and will come out together. |
| 4 | Transmission Fluid Cooler Outlet Pipe Assembly |
| 5 | Generator/Drive Motor Position Sensor Bolt M5 x 15 mm (Qty: 2)
CAUTION:
Refer to Fastener Caution
.
Tighten: 7 N.m (62 lb in) |
| 6 | Variable Drive Pulley Retaining Nut Tighten: 9 N.m (80 lb in) |
| 7 | Control Valve Body Bolt M6 x 75 mm (Qty: 1) Tighten: 9 N.m (80 lb in) |
| 8 | Control Valve Body Cover Wiring Connector Hole Seal |
| 9 | Control Valve Body Cover Gasket |
| 10 | Control Valve Body Cover Assembly |
| 11 | Control Valve Body Cover Bolt M6 x 35 mm (Qty: 15) Procedure: Tighten the bolts in sequence shown. Tighten: 9 N.m (80 lb in) |