Conditions for Running the DTC

No TP sensor DTCs P0122 or P0123.
No VSS assembly DTCs P0502 or P0503.
No TCC solenoid valve DTC P0740.
No 1-2 SS valve DTC P0753.
No 2-3 SS valve DTC P0758.
No 3-2 SS valve assembly DTC P0785.
No TFP manual valve position switch DTC P1810.
No TCC PWM solenoid valve DTC P1860.
The engine speed is greater than 450 RPM for 5 seconds.
The engine is not in fuel cutoff.
The engine torque is 68-542 N.m (50-400 lb ft).
The engine vacuum is 0-105 kPa (0-15 psi).
The TP angle is 20-99 percent.
The vehicle speed is 48-131 km/h (30-82 mph).
The engine speed is 1,500-3,000 RPM.
The speed ratio is 0.69-0.88, speed ratio is engine speed divided by the transmission output speed.
The gear range is D4.
The commanded gear is not 1st gear.
The TFT is 20-150°C (68-302°F).
The shift solenoid performance diagnostic counters are zero.