Conditions for Running the DTC

No TP sensor DTCs P0122 or P0123.
No VSS assembly DTCs P0502 or P0503.
No TCC solenoid valve DTC P0740.
No TCC stuck ON DTC P0742.
No 1-2 SS valve DTC P0753.
No 2-3 SS valve DTC P0758.
No 3-2 SS valve assembly DTC P0785.
No TFP manual valve position switch DTC P1810.
No TCC PWM solenoid valve DTC P1860.
The engine speed is greater than 450 RPM for 5 seconds.
The engine is not in fuel cutoff.
The gear range is D4.
The TP angle is greater than 10 percent.
The transmission fluid temperature is 20-130°C (68-266°F).
The system voltage is 10-18 volts.
The engine torque is 0-542 N.m (0-400 lb ft).
The transmission output speed is 150 RPM or greater.