Removal Procedure

Use the proper tool in order to separate all of the ball joints.

1. Raise the vehicle. Refer to LIFTING AND JACKING THE VEHICLE in General Information.
2. Remove the bolts (2) from the idler arm (1).
3. Remove the prevailing torque nut (5) from the idler arm (1) ball stud.

   Discard the prevailing torque nut (5).

4. Use the J 24319-B  in order to remove the relay rod (4) from the idler arm (5).
5. Remove the idler arm (5).
6. Inspect the ball stud threads for damage.
7. Inspect the ball stud seal for cuts or other damage.
8. Clean the threads on the ball stud and in the ball stud nut.