Activating System (Chevy Express & Savana)

Remove key from ignition switch. Ensure SIR fuse is still removed from fuse block. In reverse order, connect SIR component Yellow SIR connectors to vehicle harness and install CPA clips. Install SIR fuse in fuse block. Staying away from both air bags, turn ignition switch to ON position. Ensure AIR BAG warning light flashes 7 times, and then turns off. To complete installation, reverse removal procedures.

Fig 1: Locating Driver Air Bag Module 4-Pin Yellow Connector (Chevy Express & Savana)

Courtesy of GENERAL MOTORS CORP.

Fig 2: Locating Passenger Air Bag Module Yellow 4-Pin Connector (Chevy Express & Savana)

Courtesy of GENERAL MOTORS CORP.

Fig 3: Locating Right Seat Belt Pretensioner 2-Pin Connector, Left Is Similar (Chevy Express & Savana)

Courtesy of GENERAL MOTORS CORP.