Limited Slip Differential Diagnosis
- Did you review the general description and perform the necessary inspections? If so, go to next step. If not, see LOCKING/LIMITED SLIP REAR DIFFERENTIAL under DIAGNOSTIC STARTING POINT.
- Measure the rotational force of the axle using the following procedure:
- Block the front wheels.
- Raise and support the vehicle.
- Remove the tire and wheel.
- Using the Front/Rear Spindle Remover (J-28733-B), measure the rotational force of the axle. See AXLE ROTATIONAL FORCE SPECIFICATION .
- Repeat the procedure for the other axle.
- Repair the rear axle. Did you complete the repair? If so, go to next step.
- Operate the system in order to verify the repair. Did you correct the condition? If so, system is okay. If not, go to step 2 .
AXLE ROTATIONAL FORCE SPECIFICATION
| Specification | Lbs (N.m) |
|---|---|
| Axle Rotational Force | 30-200 (22-271) |