LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 995 (Engine Mechanical - 8.1L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Oil Level Indicator and Tube Installation

Oil Level Indicator and Tube Installation

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: Ensure that the oil level indicator tube does not come in contact with the spark plug wires. Route the spark plug wires around the oil level indicator tube.
  1. Install a NEW O-ring seal onto the oil level indicator tube.
  2. Install the oil level indicator tube into the oil pan.
  3. Install the oil level indicator tube bracket to the exhaust manifold stud.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the oil level indicator tube bracket bolt.

    Tighten:  Tighten the oil level indicator tube bolt to 25 N.m (18 lb ft).

    5. Fig 1: View Of Oil Level Indicator Tube & Bolt
    GM864792Courtesy of GENERAL MOTORS CORP.
  5. Install the oil level indicator into the oil level indicator tube.
    6. Fig 2: View Of Oil Level Indicator
    GM864787Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals