LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 994 (Engine Mechanical - 6.6L (LLY)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Oil Level Indicator and Tube Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install NEW O-ring seals onto the oil level indicator tube.
  2. Lightly lubricate the O-ring seals with engine oil.
  3. Install the oil level indicator tube.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the oil level indicator tube bolt at the fuel injection control module bracket.

    Tighten:  Tighten the bolt to 21 N.m (15 lb ft).

    5. Fig 1: View Of Oil Level Indicator
    GM1334847Courtesy of GENERAL MOTORS CORP.
  5. Install the starter motor. Refer to Starter Motor Replacement (6.6L (LLY) Engine) in Engine Electrical.
  6. Install the exhaust manifold. Refer to Exhaust Manifold Replacement - Right (6.6L (LLY) Engine) in Engine Exhaust.
  7. Install the oil level indicator.
scientia non olet · About LEMON Manuals