LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 994 (Engine Mechanical - 6.6L (LLY)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Flywheel Replacement (Automatic Transmission) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locking Flywheel Using J 44643
    GM660308Courtesy of GENERAL MOTORS CORP.
  1. Remove the transmission. Refer to Transmission Replacement (With 6.6L Engine) or Transmission Replacement (With 8.1L (L18) Engine) .
  2. Install J 44643  in order to hold the flywheel.
    3. CAUTION: When removing, handling or installing this component wear protective gloves. The sharp edges on the component may be very sharp and may cause injury.
  3. Remove and discard the flywheel bolts.
  4. Remove the flywheel washer and flywheel.
    5. Fig 2: View Of Flywheel & Washer (Automatic)
    GM1334818Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals