LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 994 (Engine Mechanical - 6.6L (LLY)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Drive Belt Idler Pulley Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the right side idler pulley and bolt (1).

    Tighten:  Tighten the bolt to 50 N.m (37 lb ft).

  2. Install the center idler pulley and bolt (2).

    Tighten:  Tighten the bolt to 50 N.m (37 lb ft).

    3. Fig 1: View Of Right Side Idler & Center Idler Pulley Bolts
    GM1409331Courtesy of GENERAL MOTORS CORP.
  3. If equipped with dual generators, install the left side idler pulley and bolt.

    Tighten:  Tighten the bolt to 50 N.m (37 lb ft).

  4. Install the drive belt. Refer to Drive Belt Replacement .
scientia non olet · About LEMON Manuals