LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 994 (Engine Mechanical - 6.6L (LLY)) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Oil Pump Removal

Oil Pump Removal

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Do not use an impact driver to remove or install the oil pump driven gear nut. Use of an impact driver may shear the oil pump drive gear pin in the crankshaft.
  1. While holding the secondary oil pump shaft with a hex driver, remove the oil pump driven gear nut.
    2. Fig 1: Removing/Installing Secondary Oil Pump Driven Gear Nut While Holding Oil Pump Shaft
    GM776631Courtesy of GENERAL MOTORS CORP.
  2. Remove the oil pump driven gear.
    3. Fig 2: View Of Oil Pump Driven Gear
    GM660532Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do not damage the crankshaft sensor reluctor teeth.
  3. Remove the oil pump drive gear and crank sensor reluctor assembly.
    4. Fig 3: View Of Oil Pump Drive Gear & Crank Sensor Reluctor Assembly
    GM660339Courtesy of GENERAL MOTORS CORP.
  4. Remove the oil pump bolts.
  5. Remove the oil pump.
    6. Fig 4: View Of Oil Pump
    GM660533Courtesy of GENERAL MOTORS CORP.
  6. Remove the O-ring and discard.
scientia non olet · About LEMON Manuals