LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 994 (Engine Mechanical - 6.6L (LLY)) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Crankshaft Balancer Installation

Crankshaft Balancer Installation

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Tools Required 

J 44643  Flywheel Hold Tool

  1. Lightly lubricate the crankshaft balancer internal hub with engine oil.
  2. Install the crankshaft balancer to the crankshaft.
    3. Fig 1: View Of Crankshaft Balancer & Bolt
    GM1334816Courtesy of GENERAL MOTORS CORP.
  3. Lightly lubricate the crankshaft balancer bolt with engine oil.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the crankshaft balancer bolt and washer.

    Tighten: 

    1. Tighten the bolt to 100 N.m (74 lb ft) on the first pass.
    2. Tighten the bolt an additional 90 degrees.

  5. Remove the J 44643  .
scientia non olet · About LEMON Manuals