LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 992 (Engine Mechanical - 4.3L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Valve Rocker Arm Cover Replacement - Left >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra and 2004 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the engine wiring harness bracket nuts.
    2. Fig 1: Removing Engine Wiring Harness Bracket Nuts
    GM310241Courtesy of GENERAL MOTORS CORP.
  2. Remove the engine wiring harness bracket.
  3. Remove the engine wiring harness clip bolt (4).
  4. Disconnect the engine coolant temperature (ECT) sensor electrical connector (5).
    5. Fig 2: View Of TP Sensor, IAC Motor, ECT Sensor, Control Port Injector Module & Engine Harness Clip Bolt
    GM782174Courtesy of GENERAL MOTORS CORP.
  5. Reposition the engine wiring harness and bracket.
  6. Disconnect the power brake booster vacuum hose from the vacuum fitting.
    7. Fig 3: Disconnecting Power Brake Booster Vacuum Hose
    GM869713Courtesy of GENERAL MOTORS CORP.
  7. Remove the positive crankcase ventilation (PCV) valve hose from the valve cover and rocker cover.
    8. Fig 4: Removing PCV Valve Hose
    GM869710Courtesy of GENERAL MOTORS CORP.
  8. Remove the rocker arm cover bolts.
  9. Remove and discard the rocker arm cover bolt grommets, if necessary.
  10. Remove the rocker arm cover.
    11. Fig 5: Removing Rocker Arm Cover
    GM869729Courtesy of GENERAL MOTORS CORP.
  11. Remove and discard the rocker arm cover gasket.
    12. Fig 6: View Of Rocker Arm Cover And Gasket
    GM328573Courtesy of GENERAL MOTORS CORP.
  12. Clean and inspect the rocker arm cover, if necessary. Refer to Valve Rocker Arm Cover Cleaning and Inspection .
scientia non olet · About LEMON Manuals