LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 992 (Engine Mechanical - 4.3L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Balance Shaft Bearing and/or Bushing Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra and 2004 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using J 38834  , install the balance shaft rear bearing.
    1. Install the J 38834-3 onto the short threaded end of the J 38834-1.
    2. Install the J 38834  nut, the washer, and the bearing on the long threaded end of the J 38834-1.
    3. Install the J 38834-2 onto the J 38834-1 so that the smaller diameter of the J 38834-2 will be facing the front of the engine block.
    4. Install the J 38834-2 on the inside of the balance shaft front bearing bore.
    5. Lubricate the NEW balance shaft rear bearing with clean engine oil.
    6. Install the balance shaft rear bearing onto the J 38834-2.
    7. Align the balance shaft rear bearing for installation.
    8. Using a wrench, secure the J 38834-1 into place.
    9. Rotate the J 38834  nut until the balance shaft rear bearing is properly and completely pushed into the balance shaft rear bearing bore.
    2. Fig 1: Installing Balance Shaft Rear Bearing
    GM340085Courtesy of GENERAL MOTORS CORP.
  2. Remove the J 38834  .
  3. Install the balance shaft. Refer to Balance Shaft Replacement .
scientia non olet · About LEMON Manuals