LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 992 (Engine Mechanical - 4.3L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Oil Level Indicator and Tube Installation

Oil Level Indicator and Tube Installation

WARNING: This page is about a different car, the 2004 GMC Sierra and 2004 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply sealant GM P/N 12346004 (Canadian P/N 10953480) or equivalent, around the oil level indicator tube 13 mm (0.5 in) below the tube bead.
  2. Install the oil level indicator tube into the engine block. Rotate the oil level indicator tube into position.
    3. Fig 1: Installing Oil Level Indicator Tube
    GM188009Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the oil level indicator tube bolt.

    Tighten:  Tighten the oil level indicator tube bolt to 12 N.m (106 lb in).

  4. Install the oil level indicator into the oil level indicator tube, if required.
    5. Fig 2: Installing Oil Level Indicator
    GM330580Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals