Exhaust Manifold Installation - Right
WARNING: This page is about a different car, the 2004 GMC Sierra and 2004 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Install the NEW exhaust manifold gaskets.
- Install the exhaust manifold.
- Install the spark plug wire shields.
- If reusing the fasteners, apply threadlock GM P/N 12345493 (Canadian P/N 10953488) or equivalent, to the threads of the exhaust manifold bolts.
- Install the exhaust manifold bolts.
Tighten:
- Tighten the exhaust manifold bolts on the first pass to 15 N.m (11 lb ft).
- Tighten the exhaust manifold bolts on the final pass to 30 N.m (22 lb ft).
- Install the spark plug wires to the spark plug wire retainers.
- Install the spark plug wires onto the spark plugs.
NOTE:
Refer to Fastener Notice in Cautions and Notices.