LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 991 (Engine Controls Diagnosis - 8.1L (DTC P0641 To P1111)) >> Diagnosis >> DTC P1114 >> Diagnostic Aids

Diagnostic Aids

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
DTC P1114

Step Action Yes No
Schematic Reference:  Engine Controls Schematics 
Connector End View Reference:  Powertrain Control Module (PCM) Connector End Views  or  Engine Controls Connector End Views 
1 Did you perform the Diagnostic System Check-Engine Controls? Go to Step 2  Go to Diagnostic System Check - Engine Controls
2 Observe the DTC information with a scan tool.
Is DTC P0117 set?
Go to DTC P0117 Go to Step 3 
3 Observe the engine coolant temperature (ECT) sensor parameter with a scan tool while moving the ECT sensor connector and the powertrain control module (PCM) connector.
Does the scan tool indicate an abrupt change in value?
Go to Step 5  Go to Step 4 
4 Observe the ECT parameter with a scan tool while moving the wiring harness at the ECT sensor and the PCM.
Does the scan tool indicate an abrupt change in value?
Go to Step 6  Go to Step 7 
5 Repair the ECT connector or the terminal as necessary. Refer to Circuit Testing and Connector Repairs in Wiring Systems.
Did you complete the repair?
Go to Step 7  -
6 Repair the ECT wiring or the wiring harness as necessary. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Did you complete the repair?
Go to Step 7  -
7
  1. Clear the DTCs with a scan tool.
  2. Turn OFF the ignition for 30 seconds.
  3. Start the engine.
  4. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records.
Did the DTC fail this ignition?
Go to Step 2  Go to Step 8 
8 Observe the Capture Info with a scan tool.
Are there any DTCs that have not been diagnosed?
Go to Diagnostic Trouble Code (DTC) List System OK