Installation Procedure
WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Install the air deflector to the housing.
- Install the retaining screws.
Tighten: Tighten the screws to 1.6 N.m (14 lb in).
- Connect the electrical connectors.
- Install the air deflector assembly to the I/P.
- Remove the knee bolster. Refer to Knee Bolster Replacement .
- Install the I/P bezel. Refer to Bezel Replacement - Instrument Panel (I/P) Cluster in Instrument Panel, Gages, and Console.
NOTE:
Refer to Fastener Notice in Cautions and Notices.