LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 982 (Heating, Ventilation And Air Conditioning - Gas) >> Repair Instructions >> Blower Motor Resistor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the blower motor resistor.
    Fig 1: Blower Motor Resistor
    GM382503Courtesy of GENERAL MOTORS CORP.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 2: Blower Motor Resistor Retaining Screws
    GM382493Courtesy of GENERAL MOTORS CORP.
  2. Install the blower motor resistor retaining screws.

    Tighten:  Tighten the screws to 1.6 N.m (14 lb in).

  3. Connect the electrical connection to the blower motor resistor.
    Fig 3: View Of Electrical Connector At The Blower Motor
    GM476821Courtesy of GENERAL MOTORS CORP.
  4. Connect the electrical connection to the blower motor.
  5. If equipped, install the IP sound insulator. Refer to Insulator Replacement - Instrument Panel (I/P) in Instrument Panel, Gages, and Console.
scientia non olet · About LEMON Manuals