Installation Procedure
WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Lightly coat the NEW O-ring seal with mineral base 525 viscosity refrigerant oil.
- Install the NEW O-ring seal to the switch.
- Install the A/C low pressure switch to the accumulator.
Tighten: Tighten the switch to 6 N.m (53 lb in).
- Connect the electrical connector to the A/C low pressure switch.
- Leak test the fittings of the components using the J 39400-A .
NOTE:
Refer to Fastener Notice in Cautions and Notices.