LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 981 (Automatic Transmission - 4L80-E/4L85-E (Introduction, Service & Replacement)) >> Repair Instructions >> Input Shaft Speed Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate the input speed sensor seal with automatic transmission fluid.
  2. Install the input speed sensor (1).
    NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 1: View Of Input & Output Speed Sensors
    GM686957Courtesy of GENERAL MOTORS CORP.
  3. Install the input speed sensor bolt.

    Tighten:  Tighten the bolt to 11 N.m (96 lb in).

    4. Fig 2: Connecting The Input Speed Sensor Electrical Connector
    GM859361Courtesy of GENERAL MOTORS CORP.
  4. Connect the input speed sensor electrical connector (1).
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals