LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 979 (Exterior Trim) >> Repair Instructions >> Wheel Opening Flare Replacement - Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Install in an environment that is free from dust or dirt. Dust and dirt could come in contact with the adhesive surface and prevent proper adhesion.
  1. Clean the area where the wheel opening flare is to be mounted.

    Use a suitable solvent, such as flash naphtha or a mixture of 50 percent isopropal alcohol and 50 percent water.

  2. Dry the area thoroughly.
  3. Warm the body panel with a heat gun J 25070  to a minimum of 21°C (70°F).
    4. IMPORTANT: Do not touch the adhesive surface when the tape is removed.
  4. Remove the adhesive tape from the wheel opening flare.
  5. Install the wheel opening flare to the rear fender.
  6. Install the push pins to retain the wheel opening flare.
    7. Fig 1: Installing Rear Wheel Opening Flare
    GM348521Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals