Installation Procedure
WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Clean the area where the replacement molding is to be mounted. Use a suitable solvent such as flash naphtha or a mixture of 50 percent isopropyl alcohol and 50 percent water.
- Dry the area thoroughly.
- Warm the body panel to a temperature range of 16-41°C (60-105°F) with a heat lamp or heat gunJ 25070 .
- Ensure the molding is at a minimum temperature of 16°C (60°F).
If the temperature of the molding is below 16°C (60°F), warm up molding with a heat lamp or heat gunJ 25070 .
- Remove the protective tape from the molding.
- Without allowing the adhesive surface to touch the door, ensure the molding is aligned.
- Press on the molding in order to install to the door.
IMPORTANT:
Apply the molding in an environment free of dust and dirt. Dust and dirt could come in contact with the adhesive surface and prevent proper adhesion.
IMPORTANT:
Do not touch the adhesive surface when the tape is removed.