LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 979 (Exterior Trim) >> Repair Instructions >> Emblem/Nameplate Replacement - Pickup Cab >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. If the location of the emblem/nameplate has not been marked apply tape, using the dimensions in the graphic.
  2. Warm the pickup cab surface with a heat gun J 25070  152 mm (6.0 in) from the surface to a minimum of 21°C (70°F).
    3. Fig 1: Pickup Cab Emblem/Nameplate Measurements
    GM370128Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do not touch the adhesive backing of the emblem/nameplate.
  3. Remove the backing from the front end of the emblem/nameplate.
  4. Press the emblem/nameplate to the pickup cab panel surface while continuing to remove the backing.
  5. Hand roll the emblem/nameplate to the pickup cab panel to ensure proper adhesion.
  6. Inspect the emblem/nameplate for bonding.
  7. Remove the tape from the area around the pickup cab emblem.
scientia non olet · About LEMON Manuals