LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 979 (Exterior Trim) >> Repair Instructions >> Emblem/Nameplate Replacement - Endgate (SS) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: Use the tape for protection and alignment marks for alignment of the new emblem/nameplate.
  1. Apply tape to the area around the end gate emblem/nameplate.
  2. Heat the emblem/nameplate, using a heat gun J 25070  152 mm (6.0 in) from the surface.
  3. Apply the heat using a circular motion for about 30 seconds.
    4. NOTE: Refer to Exterior Trim Emblem Removal Notice in Cautions and Notices.
  4. Remove the emblem/nameplate from the end gate surface using a plastic, flat-bladed tool.
    5. Fig 1: Endgate Emblem/Nameplate Positioning (SS)
    GM1228739Courtesy of GENERAL MOTORS CORP.
  5. Remove all adhesive from the end gate panel surface and the back of the emblem/nameplate using 3M™ Scotch Brite molding adhesive remover disk 3M™ P/N 07501 or equivalent.
  6. Clean the end gate surface using varnish makers and painters (VMP) naptha.
scientia non olet · About LEMON Manuals