LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 979 (Exterior Trim) >> Repair Instructions >> Emblem/Nameplate Replacement - Door (SS) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. If the location of the emblem/nameplate has not been marked apply tape.
  2. Use the following dimensions in order to mark the proper position of the emblem/nameplate on the door.
    • 105 mm (4.1 in) (A) From the vertical edge
    • 22 mm (0.9 in) (B) From the horizontal edge
    3. Fig 1: Door Emblem/Nameplate Measurements (SS)
    GM1233628Courtesy of GENERAL MOTORS CORP.
  3. Warm the door surface with a heat gun J 25070  152 mm (6.0 in) from the surface to a minimum of 21°C (70°F).
  4. Apply tape over the outer surface of the emblem/nameplate to ensure alignment.
    5. IMPORTANT: Do not touch the adhesive backing of the emblem/nameplate.
  5. Remove the backing from the front end of the emblem/nameplate.
  6. Press the emblem/nameplate to the door panel surface while continuing to remove the backing.
  7. Hand roll the emblem/nameplate to the door panel to ensure proper adhesion.
  8. Inspect the emblem/nameplate for bonding.
  9. Remove the tape from the emblem/nameplate and the area around the door emblem/nameplate.
scientia non olet · About LEMON Manuals