LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 971 (Transfer Case - NVG 246-NP8) >> Repair Instructions >> Transfer Case Output Shaft Seal Replacement - Front >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra and 2004 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement .
  2. Remove the front propeller shaft. Refer to Propeller Shaft Replacement - Front in Propeller Shaft.
  3. Insert a flat-tipped screwdriver into the inner race.
  4. Pry the inner race back.
    5. Fig 1: Prying Inner Race Back
    GM749439Courtesy of GENERAL MOTORS CORP.
  5. Insert a small pry bar into the inner race.
    6. Fig 2: Inserting Small Pry Bar Into Inner Race
    GM749435Courtesy of GENERAL MOTORS CORP.
  6. Remove the inner part of the seal.
    7. Fig 3: Removing Inner Part Of Seal
    GM749436Courtesy of GENERAL MOTORS CORP.
  7. Insert a flat-tipped screwdriver or a small pry bar in the space between the outer race of the seal and the transfer case.
    8. Fig 4: Inserting Screwdriver Between Front Output Shaft Seal Outer Lip & Transfer Case
    GM749437Courtesy of GENERAL MOTORS CORP.
  8. Remove the outer part of the seal.
    9. Fig 5: Removing Outer Part Of Seal
    GM749438Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals