LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 970 (Rear Wheel Steering System) >> Repair Instructions >> Rear Wheel Steering Tie Rod End Replacement - Outer >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Refer to Rear Wheel Steering Lifting and Jacking Notice in Cautions and Notices.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  3. Fig 1: Removing Tie Rod Bracket Retaining Bolts From The Steering Knuckle
    GM742190Courtesy of GENERAL MOTORS CORP.
  4. Remove the tie rod bracket (2) retaining bolts (1) from the steering knuckle.
  5. Fig 2: Loosening The Tie Rod Jam Nut
    GM742247Courtesy of GENERAL MOTORS CORP.
  6. Loosen the tie rod jam nut (1).
  7. Remove the nut retaining the outer tie rod end to the steering knuckle.
  8. Fig 3: Removing Outer Tie Rod End From The Steering Knuckle
    GM742180Courtesy of GENERAL MOTORS CORP.
  9. Using the J 24319-B  (1), remove the outer tie rod end from the steering knuckle.
  10. Remove the outer tie rod end from the inner tie rod.