Removal Procedure
WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the power steering pulley. Refer to Power Steering Pulley Replacement .
- Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Remove the oil pan skid plate bolts.
- Remove the oil pan skid plate from the vehicle, if equipped.
- Place a drain pan under the vehicle.
- Remove the power steering pressure hose (2) from the power steering pump from underneath the vehicle.
- Lower the vehicle.
- Remove the clamps (3,5) retaining the power steering return hoses to the power steering pump and remove the hoses.
- Remove the lower intermediate shaft from the steering gear. Refer to Intermediate Steering Shaft Replacement - Lower in Steering Wheel and Column.
- Remove the bolt retaining the rear bracket to the engine.
- Remove the bolts from the front of the pump.
- Remove the pump from the vehicle.
- Remove the bracket (3) from the rear of the pump (1).