LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 955 (Battery, Charging System & Starting System) >> Repair Instructions >> Starter Motor Replacement (6.6L (LB7) Engine) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (Single Battery)  or Battery Negative Cable Disconnect/Connect Procedure (Auxiliary Battery) .
  2. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  3. If equipped with 4-wheel drive (4WD), remove the right front tire and wheel. Refer to Tire and Wheel Removal and Installation in Tire and Wheel.
  4. If equipped with 4WD, remove the right fender wheelhouse inner panel (1).
    5. Fig 1: View Of Wheelhouse Panel & Push-In Retainers
    GM401885Courtesy of GENERAL MOTORS CORP.
  5. Remove the battery positive cable from the starter motor.
    6. Fig 2: View Of Positive Battery Cable Nut & Cable From The Starter (6.6L)
    GM674619Courtesy of GENERAL MOTORS CORP.
  6. Remove the solenoid wires.
    7. Fig 3: View Of Starter Motor & Bolts (6.6L (LB7))
    GM660305Courtesy of GENERAL MOTORS CORP.
  7. Remove the starter motor bolts.
  8. Remove the starter motor.
scientia non olet · About LEMON Manuals