LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 955 (Battery, Charging System & Starting System) >> Repair Instructions >> Energy Storage Box (ESB) 120V Cable Replacement (5.3L Engine w/RPO HP2) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the 120-volt AC electrical connector (3).
    2. Fig 1: View Of 42-Volt Positive/Negative Cable Electrical Connector, AC Electrical Connector, Ground Strap & Stud
    GM1237048Courtesy of GENERAL MOTORS CORP.
  2. Remove the energy storage box (ESB) intermediate cover. Refer to Energy Storage Box (ESB) Trim Cover Replacement (5.3L Engine w/RPO HP2) .
  3. Remove the receptacle outlet cover screws (1).
    4. Fig 2: View Of Receptacle Box & Outlet Screws (5.3L Engine w/RPO HP2)
    GM1343181Courtesy of GENERAL MOTORS CORP.
  4. Remove the 120-volt cable connector screws.
    5. Fig 3: View Of 120-Volt Cable Connector Screws (5.3L Engine w/RPO HP2)
    GM1403630Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the retainers securing the 120-volt cable to the ESB.
  6. Note the routing of the 120-volt cable.
    7. Fig 4: View Of 120-Volt Cable (5.3L Engine w/RPO HP2)
    GM1403631Courtesy of GENERAL MOTORS CORP.
  7. Remove the 120-volt cable (1) out through the receptacle opening (2) in the ESB.
    8. Fig 5: View Of 120-Volt Cable & Receptacle Opening (5.3L Engine w/RPO HP2)
    GM1343186Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals