Removal Procedure
WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Refer to Battery Disconnect Caution in Cautions and Notices.
- Disconnect the auxiliary battery negative cable (2). Refer to Battery Negative Cable Disconnect/Connect Procedure (Single Battery) or Battery Negative Cable Disconnect/Connect Procedure (Auxiliary Battery) .
- Unsnap the positive battery cable cap.
- Disconnect the positive battery cable (1).
- Remove the auxiliary battery cable clip from the fender wheelhouse inner panel.
- Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Remove the cable clip bolt (5) at the frame.
- Remove the auxiliary battery negative cable bolt (4).
- Remove the battery cable retainer nut (6) and the retainer.
- Remove the battery positive cable from the retainer.
- Remove the positive battery cable nut (7).
- Remove the positive battery cable lead (8) from the starter.
- Remove the auxiliary battery cable.