LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 955 (Battery, Charging System & Starting System) >> Repair Instructions >> Battery Negative Cable Replacement - Auxiliary (6.0L and 8.1L Engines) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: Install the engine wiring harness ground terminal on top of and inboard of the auxiliary negative battery cable ground crimp.
  1. Install the auxiliary negative battery cable.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the engine wiring harness/auxiliary negative battery cable bolt.

    Tighten:  Tighten the bolt to 16 N.m (12 lb ft).

    3. Fig 1: View Of Engine Wiring Harness/Auxiliary Negative Battery Cable Bolt
    GM662418Courtesy of GENERAL MOTORS CORP.
  3. Install the engine sight shield. Refer to Engine Sight Shield Replacement (4.8L, 5.3L, and 6.0L Engines) or Engine Sight Shield Replacement (6.0L Engine w/RPOs Y91 and Z88) in Engine Mechanical - 4.8L, 5.3L, and 6.0L.
  4. Install the auxiliary battery cable clips to the studs at the front of dash.
    5. Fig 2: View Of Auxiliary Battery Negative Cable (6.0L & 8.1L)
    GM662415Courtesy of GENERAL MOTORS CORP.
  5. Connect the auxiliary battery negative cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (Single Battery)  or Battery Negative Cable Disconnect/Connect Procedure (Auxiliary Battery) .
scientia non olet · About LEMON Manuals