Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: The flywheel spacer (if applicable) must be removed prior to pilot bearing installation.

Install a 5/8 inch washer (1) onto the J 38836 or equivalent.

Fig 1: Installing Clutch Pilot Bearing And Washer On J 38836
Courtesy of GENERAL MOTORS CORP.
Install a NEW clutch pilot bearing (2) onto the tool.

Fig 2: Installing The New Clutch Pilot Bearing Into The Crankshaft

Courtesy of GENERAL MOTORS CORP.

Install the NEW clutch pilot bearing into the crankshaft using J 38836 .

Fig 3: Inspect The Clutch Pilot Bearing For Proper Installation Depth

Courtesy of GENERAL MOTORS CORP.

Inspect the clutch pilot bearing for proper installation.
Install the clutch assembly. Refer to Clutch Assembly Replacement .