LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 952 (Engine Controls - 4.3L (Introduction)) >> Repair Instructions >> Heated Oxygen Sensor (HO2S) Replacement Bank 1 Sensor 1 >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra and 2004 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Disconnect the connector position assurance (CPA) retainer.
    NOTE: Refer to Heated Oxygen and Oxygen Sensor Notice in Cautions and Notices.
  3. Disconnect the heated oxygen sensor (HO2S) electrical connector (1).
    4. Fig 1: View Of O2 Sensor Harness Routing
    GM664951Courtesy of GENERAL MOTORS CORP.
  4. Remove the bank 1 HO2S (1).
    5. Fig 2: View Of Bank 1 & 2 HO2S
    GM815044Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals