LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 952 (Engine Controls - 4.3L (Introduction)) >> Repair Instructions >> Evaporative Emission (EVAP) Hoses/Pipes Replacement - Chassis/Canister >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra and 2004 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Clean all the EVAP pipe connections and surrounding areas before disconnecting in order to avoid possible evaporative emission (EVAP) system contamination.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Disconnect the EVAP purge pipe from the chassis EVAP purge pipe.
  3. Disconnect the EVAP purge pipe from the EVAP canister.
  4. Remove the EVAP purge pipe from the clip.
    5. Fig 1: View Of EVAP Hoses/Pipes (Chassis/Canister)
    GM878134Courtesy of GENERAL MOTORS CORP.
  5. Cap the EVAP purge pipe and canister in order to prevent possible EVAP system contamination.
scientia non olet · About LEMON Manuals