LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 952 (Engine Controls - 4.3L (Introduction)) >> Repair Instructions >> Evaporative Emission (EVAP) Hoses/Pipes Replacement - Chassis/Canister >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra and 2004 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the caps from the EVAP purge pipe and canister.
  2. Connect the EVAP purge pipe to the EVAP canister.
  3. Connect the EVAP purge pipe to the chassis EVAP purge pipe.
  4. Install the EVAP purge pipe to the clip.
    5. Fig 1: View Of EVAP Hoses/Pipes (Chassis/Canister)
    GM878134Courtesy of GENERAL MOTORS CORP.
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals