LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 952 (Engine Controls - 4.3L (Introduction)) >> Repair Instructions >> Evaporative Emission (EVAP) Hoses/Pipes Replacement - Canister/Fuel Tank >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra and 2004 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the caps from the sending unit and roll over valve.
  2. Install the EVAP pipe to the fuel tank.
  3. Install and connect the EVAP pipe (1) to the sending unit (2), roll over valve (3), and fuel tank clips (6).
    4. Fig 1: View Of EVAP Hoses/Pipes (Canister/Fuel Tank)
    GM396067Courtesy of GENERAL MOTORS CORP.
  4. Install the fuel tank. Refer to Fuel Tank Replacement 
scientia non olet · About LEMON Manuals