LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 952 (Engine Controls - 4.3L (Introduction)) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Vent Solenoid Valve Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra and 2004 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Disconnect the evaporative emission (EVAP) canister vent valve electrical connector (1).
    3. Fig 1: View Of EVAP Canister Vent Valve Electrical Connector, Chassis Harness Ground Strap, Fuel Tank Ground Strap Bolt & Fuel Tank Ground Strap
    GM815635Courtesy of GENERAL MOTORS CORP.
  3. Remove the EVAP canister vent valve bracket bolt.
  4. Remove the EVAP pipe from the clips (1).
  5. Disconnect the EVAP vent pipe (4) from the EVAP canister.
  6. Remove the EVAP canister vent valve and pipe from the vehicle.
  7. If necessary, disconnect the EVAP vent pipe (3) from the EVAP canister vent valve (2).
  8. If necessary, detach the EVAP canister vent valve (2) from the bracket.
    9. Fig 2: View Of EVAP Canister, Vent Pipe & Vent Valve
    GM385856Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals