LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 952 (Engine Controls - 4.3L (Introduction)) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra and 2004 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Disconnect the evaporative emission (EVAP) purge pipe from the chassis EVAP purge pipe.
    3. Fig 1: View Of EVAP Hoses/Pipes (Chassis/Canister)
    GM878134Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the fuel tank EVAP pipe from the EVAP canister.
    4. Fig 2: View Of Fuel Tank EVAP Pipe At EVAP Canister
    GM878140Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the EVAP vent valve pipe from the EVAP canister.
    5. Fig 3: EVAP Vent Valve Pipe At EVAP Canister
    GM878143Courtesy of GENERAL MOTORS CORP.
  5. Remove the EVAP canister bracket bolt.
  6. Remove the EVAP canister.
    7. Fig 4: View Of EVAP Canister
    GM878131Courtesy of GENERAL MOTORS CORP.
  7. Remove the EVAP pipe from the EVAP canister, and retaining clip.
  8. Remove the EVAP canister from the bracket.
scientia non olet · About LEMON Manuals