LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 952 (Engine Controls - 4.3L (Introduction)) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Purge Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra and 2004 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the purge solenoid to the intake manifold.
  2. Install the engine wiring harness bracket to the stud.
    3. Fig 1: View Of Purge Solenoid
    GM309179Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the purge solenoid nuts.

    Tighten:  Tighten the nuts to 12 N.m (106 lb in).

    4. Fig 2: View Of Purge Solenoid Nuts
    GM309187Courtesy of GENERAL MOTORS CORP.
  4. Connect the purge solenoid electrical connector (1).
    5. Fig 3: EVAP Canister Purge Solenoid Valve & MAP Sensor
    GM782178Courtesy of GENERAL MOTORS CORP.
  5. Connect the EVAP purge pipe.
    6. Fig 4: View Of EVAP Purge Pipe
    GM869711Courtesy of GENERAL MOTORS CORP.
  6. Install the air cleaner outlet resonator. Refer to Air Cleaner Outlet Resonator Replacement .
scientia non olet · About LEMON Manuals