Fuel Feed and Fuel Return Pipe Purge Procedure
WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Pump the primer located on top of the fuel filter 30 times or until stiff.
- Attempt to start and run the engine. If the engine does not start, repeat step 1.
- Allow to run for 5 minutes at idle.
- Check for fuel leaks.
- Clear all engine diagnostic trouble codes (DTCs).